Sculpture Base II
3D 프린트 모델

Print ready base.



Measure units are millimeters, the figure is about 138 mm in width.


Mesh is manifold, no holes, no inverted faces, no bad contiguous edges.

Available formats: .blend, .stl, .obj, .fbx, .dae

Here is two versions of the model:

1) Base_x_sld. (blend, .obj, .fbx, .dae. stl) This files contains solid(one piece) base. The model consists of 145134 triangular faces.

2) Base_x_parts. (blend, .obj, .fbx, .dae. stl) Here are two prats, the upper part has a pin. The lower part has a socket. Here is 161608 triangular faces.

For stl format, each part is in a separate file, and there is additional upper part (Base_x_parts_3.stl), it has slightly smaller pin, just for the case if you printer tends to make recessions smaller than they are. LCD Printers may do this. 프린트 준비: 아니오