Radar Building 로우 폴리곤 3D 모델

$15.00
Radar Building 3D 모델
$ 15.00
제거 이 아이템 북마크
  • 이용 가능한 포맷:
    Autodesk FBX: fbx 13.80 MB
    렌더: Cycles
    Image Textures: png 13.29 MB
    Wavefront OBJ: obj 13.80 MB
  • 폴리곤:
    686
  • 버텍스:
    2147
  • 애니메이티드:
    No
  • 텍스쳐드:
  • 리그드:
    No
  • 재료:
  • 로우 폴리곤:
  • 컬렉션:
    No
  • UVW 매핑:
  • 플러그인 사용 됨:
    No
  • 프린트 준비:
    No
  • 3D 스캔:
    No
  • 성인용 콘텐츠:
    No
  • PBR:
    No
  • 지오메트리:
    Polygonal
  • 언래핑 된 UVs:
    Non-overlapping
  • 조회:
    769
  • 날짜:
  • 아이템 ID:
    478769
  • 평점:
A radar tower is a tower whose function is to support a radar facility, usually a local airport surveillance radar, and hence often at or in the vicinity of an airport or a military air base. In addition, radar towers are used for the installation and operation of search and height finder radars at military radar stations where the mission is to support air defense missions. These missions were characterized as Aircraft Control & Warning (AC&W) or Long Range Surveillance in support of the Semi-automatic Ground Environment (SAGE).

The tower typically has a continuously rotating parabolic antenna. Often the antenna is protected from the weather by a radome and is thus not visible from the outside.

For regional air traffic control, en route radar installations are used; for example there are six of these in Germany, erected at selected sites. The data from these radars is fed into the civilian RADNET system and transferred to all civil and military control centres.

Ideally a radar tower is built on a high spot in the terrain, because this reduces the angle of elevation and thus increases the range of the radar device. In the absence of a suitable high spot, radar towers are used. Radar towers are also need to provide weather protection and services (air conditioning and power) for the radar equipment, communications, operators and maintainers

In Germany the operational command posts of the German Air Force use the Bundeswehr radar towers for the stationary radar sites of the operational command areas.

Military radar stations have supported US and allied air defense operations at numerous worldwide locations since World War II. The largest network of military radar stations evolved during the Cold War era to support the air defense of North America as part of the joint US and Canadian command known as the North American Air Defense Command (NORAD). This military radar network became automated in 1960 with the operation of SAGE. SAGE provided the vital command, control, communications, and computers (C4S). Long Range Radar (LRR) stations were electronically connected to SAGE Direction Centers (DCs). This resulted in an integrated air defense system made up of radar, radio, interceptor aircraft, antiaircraft guns and missiles, and command and control (C2) facilities. Most of the radar and radio facilities were not on a military air base, but smaller Air Force Stations (AFS) usually located in rural and often isolated locations often miles away from even small towns. They were manned by up to several hundred Air Force personnel. An online radar museum provides descriptions of military radar stations at radomes.org/museum. Photographs of radar towers and radomes are provided. This includes the AN/FPS-24 search radar tower in a huge 64 foot square, 85 foot tall, five story building. On top of this radar tower was a radar antenna 50 feet tall, 120 feet wide, weighing 85.5 tons and rotating at 5 rpm. An available rigid radome 140 feet in diameter and 96 feet high protected this antenna from adverse weather conditions. 프린트 준비: 아니오
다른 포맷이 필요하세요?
다른 포맷이 필요하시면, 새로운 지원 티켓을 열어 요청하세요. 저희는 3D 모델을 다음으로 변환할 수 있습니다: .stl, .c4d, .obj, .fbx, .ma/.mb, .3ds, .3dm, .dxf/.dwg, .max. .blend, .skp, .glb. 우리는 3D 장면을 변환하지 않습니다 .step, .iges, .stp, .sldprt와 같은 형식도 포함됩니다.!

다운로드 Radar Building 3D 모델 fbx png obj 발신 Amrjr

radar building tower military airport technology base radartower army army-base war game
이 아이템에 대한 코멘트 없음.